I am trying to setup two 2524s with a wan from cox cable just to test. I can get the 2524 closest to the cox connection to work fine, but when i connect the next one on the lan side, i cant ping the cox gateway. I can ping the 1st routers wan int, which is the ip given by cox and on the same subnet as the cox gateway. If i create a default route on the first router to push all requests through the cox gateway why doesnt the routing table understand to send it through the cox gateway when i ping from the second router?
Normally I disable icmp (ping) from a perimeter routers interfaces. I believe it is enabled by default though but that probably is not what is wrong. You may want to set a static route from your routers to the cox gateway. Unless you have a DNS server on your inside network pinging to a "name" will fail. To solve this use the ip host command.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...