Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Basic Routing issue

Hi,

I have 2 routers with a pix in the middle, the pix has an ip of 192.168.1.7 there is then a VPN connection to a remote site with the address range 192.168.254.0

I have added the route as shown below for the 192.168.254.0 network and I can ping Servers on the network from the Router but not from a client on the LAN (address range 192.168.0.0). I know this is basic but my tired mind is getting annoyed! Help!

interface FastEthernet0/0

ip address 192.168.0.254 255.255.255.0

ip access-group 102 in

no ip redirects

no ip unreachables

no ip proxy-arp

ip nat inside

ip virtual-reassembly

ip route-cache flow

duplex auto

speed auto

no mop enabled

!

interface FastEthernet0/1

ip address 192.168.1.254 255.255.255.0

no ip redirects

no ip unreachables

no ip proxy-arp

ip ips sdm_ips_rule in

ip route-cache flow

duplex auto

speed auto

no mop enabled

ROUTES

ip classless

ip route 0.0.0.0 0.0.0.0 Dialer0

ip route 192.168.254.0 255.255.255.0 192.168.1.7

2 REPLIES
Cisco Employee

Re: Basic Routing issue

Hi,

What are the Access-List Entries for "ip access-group 102 in" on Fa0/0. Are you allowing traffic from 192.168.0.x to go to 192.168.254.x.

And can you post the full configuration. Make sure that you remove all sensitive information, like passwords and public IP's before posting the configuration.

Regards,

Arul

Re: Basic Routing issue

Hi,

In addition to checking the ACL, can you check whether the router or layer 3 device at the remote site has a route to get to the 192.168.0.0/24 network.

HTH

Sundar

87
Views
0
Helpful
2
Replies