Other Network Architecture Subjects

One of my customer would like to save all the configuration for an MGX.We are using the command saveallcnf but, then, we are not able to connect with ftp client.Every user we try to log we always receive the message login failed.How can I connect thr...

I have a 3500 XL connected to two 2600's running HSRP that won't talk to each other. I have other customers routers connected to this same switch not doing HSRP that work fine. It's a simple config with a vlan. Stupid question; does the 3500 support ...

How can i know the exact SUP type for a remote 4506 switch by teleneting into it, for example, if it is type 2 or type 2 plus ?

We are trying to integrate CiscoWorks with Tivoli Netview. We have downloaded the adapter for AIX. We have AIX 5.2 When trying to install the adapter, it`s says that we need AIX 5.1. We can`t use it at all on AIX 5.2. What can I do ? Do Cisco hav...

Hi,I'm trying to determine what the best router is for doing home hosting/biz.172117121711It seems given my ADSL connection and router from SBC that the 1711 would serve my needs best but the Cisco Small Business Network Designer suggested a 1721.Any...

When will IPv6 be supported on the Catalyst 4500 supervisor cards (II+ and IV for instance) ?

Dear Friends, We do have to provide an ISDN backup soluiton for a customer who is having primary link Ethernet based RF.Customer is connected like this : Cisco 1721 - serial towards ISP,1 BRI, ethernet to RF modem and on the other end RF modem to ...

Dear All,We want the part Number for cable to connect E1/T1 Pri ModuleE1/T1 Pri module has a RJ48 connectorWhereas E1 Modem has a RJ-45 connector labelled DTE.Kindly advice.

I hope I'm in the correct forum for this question. Anyway, I have many routers and PIX firewalls that I would like to automate the config backups on. I know CiscoWorks does it, but frankly I don't care for the product. Are there any other ways to ...

HiI have an issue like this:I use a 2511 Access Servers to aggregate 16 Serial-enabled devices. Idea is to carry Serial Device communication from an Async Line, through a TCP session in a particular port, up to a Processing Server.My problem is that ...

Is it possible to change the prompt on a cat 5500 using snmp. I am anle to change the sysname by have searched every mib i can think of for something that will change the prompt.

I need to activate DHCP on a cisco router (827)I've looked at the options that i have but i don't really get it. I want to put in a scope 10.200.22.100 till 10.200.22.200 with a 255.255.0.0 subnet mask. With what commands can i do this?Also i would l...

adelphia, my cable provider issues IP addresses via DHCP. i've set my 2611 to get it's address from the DHCP server with the command "ip address dhcp"as you can guess, it's not working. i can't nab an address from the server.i removed all ACL's to ...