I am asked to create VLANs on L2 Switches 2950 Model. IOn a Test Switch Ientered into interface mode and given the below Command on one of the ports.
The test Switch is Uplinked to our live Network from a Series of Switches which are not in VLANs.
Switch2(config-if)#switchport access vlan 10
I attached a workstation to VLAN 10 port. I am not able to ping my Network.
on Other Ports of the test Switch I am able to Ping.
I also created a secondary interface on My Router Running Eth Port and kept the WOrkstation in the same subnet of the secondary interface created n the Router. My gateway entry on W/S is also Correct. I am missing some thing I beleive. Can any one pl. help me.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...