Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
185
Views
0
Helpful
1
Replies

BGP Conditional Advertisement With 2 Subnets

admin_2
Level 3
Level 3

‎06-24-2002 02:37 PM - edited ‎03-01-2019 10:25 PM

Is it possible to trigger conditional advertisement of a Border Gateway Protocol (BGP) prefix based upon the non-existence of two subnets? I can only get this to work with one subnet.

My customer has parallel links to a provider (one BGP session).

The command reference mentions one subnet in the description of the non-exist-map.

Perhaps I should just identify one network from this Internet Service Provider (ISP) to focus on as the indicator of the failure.

Labels:
0 Helpful
1 Reply 1

Not applicable

‎06-24-2002 02:37 PM

An IP address match is mandatory for a non-exist-map. The access-list specified should be a simple access-list and contains only one prefix. If the condition requires multiple prefixes, multiple access-list can be used, for example:

route-map ISP1-backbone permit 10

match ip address 2 3 4

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents