They both support BGP/MPLS, but how you plan to implement BGP/MPLS is the critical factor.
- how many BGP routes are you going to hold? If you are looking to load full routes from the Internet, then you likely need 256MB RAM (which the 2600 can't support, and only a few 3600's can), less if you are storing partial BGP routes.
- how "fancy" will the BGP/MPLS config be? The more tweaking you do to either protocol, the more processing power you'll need in order to do it.
- what WAN circuit speed do you need to support (or upgrade to)? The more throughput required, the more processing/RAM needed.
Without any details (and assuming this is not a test lab scenario), I would suggest looking at more hefty routers in the 7000 (7200/7500/7600) series since they can support more RAM and faster processors. If I were you I'd definitely pilot this before going into production.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.