hardware is cat6500 with sup2 (512MB dram)/msfc2 (512MB dram) and sfm2.
software is ADV IP W/MPLS/IPV6/SSH/3DES + BGP 12.2(8)SXD6.
bgp is configured with 3 ebgp peers and 8 ibgp peers. currently i filter only about 40 prefixes from ebgp peers.
when i remove inbound filters and try to receive entire internet bgp table router just stops. no traffic forwarding, no response, it seems like it is shut down. console response is very slow and bgp router process takes up 100% cpu.
only thing that will make it work again is reload.
What is the IOS version you are using in your 6500 switch?.Give the exact version no u r using ,since for each version of cat switch, there is a separate documentation guide which may provide some detailed info.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.