Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

BGP - Route Reflector

Is there a way to see the Cluster-ID on the route-reflector itself? I know I can see it at the client with 'show ip bgp [PREFIX]', but I am looking for a way to do it on the route-reflector itself.

Thanks

Mike

1 REPLY
Purple

Re: BGP - Route Reflector

Mike,

I don't believe you can see it attached to any routes on the route reflector itself. But then, you don't really need to - the cluster id is whatever you configure with the bgp cluster-id command or the BGP router-id of the box if you haven't explicitly configured the cluster ID.

I would appreciate you rating the post if it helps.

Paresh

113
Views
5
Helpful
1
Replies
CreatePlease to create content