BGP VPNv4 Route-Refresh

[rabeder]

Hi,

i have a BGP speaking router, which has only VPNv4 adress-family enabeld.

No IPv4 !

1.) I am not able to force route-refresh or Soft Clear of a other VPNv4 neighbour.

Is it a prerequisite to enable IPv4 - but i have no need to do this ( i only need VPNv4 for MPLS)

2.) I am also not able to do the following:

GRZMPLS3#sh ip bgp vpnv4 all neighbors 10.22.208.250 received-routes

% Inbound soft reconfiguration not enabled on 10.22.208.250

BUT i have reconfig enabeld - on the IPv4 family - i am not able to enable this in the VPNv4 family !

Any idea ?

[ciscomoderator]

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.