I have used a Cisco 2600 series router with two T1 connections setup with a shadow line from my ISP. I now also have a frame relay connection to a remote office. I would like to know if the 2600 can handle using the frame connection as a backup route to the internet the same way it currently uses the two T1's. I also have a Cisco 3600 on the frame connection at this time. Any of these can be used for this project. I just would like to know if any of these routers can do the job? The end result should be one T1 connection and 1 frame connection used as a backup route instead of the current configuration of one active T1 and one shadow T1. Thanks for any thoughts. Also, any installation tips would be helpful.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...