Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Bizarre C4006 Catalyst issue

I was working in my server room over the weekend doing some cable management and cleanup and we decided to reboot the switch. I saved off the configuration and proceeded to power it down and then back up again. Low and behold, the configuration for everything was still there EXECPT FOR the individual switchports and their VLAN assignments and such. Any ideas as to why this would disappear?????

I reposted the config back to the switch and it was fine. We rebooted the switch a couple more times but could not reproduce the problem.

Thanks.

Michael

2 REPLIES

Re: Bizarre C4006 Catalyst issue

Hi,

I've noticed something similar last year with CatOS 7.2.1 uprgade.

See http://forums.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40%40.ee8995f/0#selected_message

The problem also was not reproducible.

What CatOS version re you running?

Regards,

Milan

New Member

Re: Bizarre C4006 Catalyst issue

I'm user version 12.1(8a)EW1. I have not been able to reproduce the problem, however this kind of makes me nervous that should I have a power failure or something of that nature where the switch goes down, it will not come back up properly.

87
Views
0
Helpful
2
Replies