08-06-2013 01:53 AM - edited 03-03-2019 07:08 AM
Hi...
I have a serious issue...My WAN router was crashed after a power failure. When I restart the router it is directly going to rommon mode..
I run the following commands:
rommon 2 > confreg
rommon 3 > reset
rommon 1 > dir flash:
rommon 2 > boot flash:imgname.bin
But still its showing the software is crashed and again going to rommon mode.
What can be problem? Is it the problem with flash. But I can all the required files inside flash
08-06-2013 02:46 AM
Can you post the log showing your router trying to load the IOS image and crashing please? You might have a corrupted image - you could try reloading the image via TFTP.
08-06-2013 04:19 AM
Post the entire bootup process. Your router could have a hardware failure.
08-06-2013 04:57 AM
I cannot access the router through console too. How can I check the logs and bootup process. I think its hardware crash.
08-06-2013 05:15 AM
You must be accessing the router through the console or you would not be able to do the rommon stuff
08-06-2013 07:22 AM
No router type mentioned. No complete boot log. No help possible.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: