Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

boot system

I have the following boot commands in my switch and I need to remove the "BOOT variable = disk0:,1;sup-bootflash:c6sup22-psv-mz.121-12c.E4.bin,1"

Can someone give me the config command to accomplish this?

This is the output of the show boot command.

Switch#sh boot

BOOT variable = disk0:,1;sup-bootflash:c6sup22-psv-mz.121-12c.E4.bin,1;disk0:c6k

222-psv-mz.122-17d.SXB.bin,1

CONFIG_FILE variable does not exist

BOOTLDR variable = bootflash:c6msfc2-boot-mz.121-8a.EX

Configuration register is 0x2102

4 REPLIES

Re: boot system

Hi Friend,

Can you just try with "no boot system" command by which I mean

no boot system flash disk0:

no boot system flash sup-bootflash:c6sup22-psv-mz.121-12c.E4.bin

HTH, if yes please rate the post.

Ankur

New Member

Re: boot system

Hi Ankur,

Would the "no boot system flash disk0:

no boot system flash sup-bootflash:c6sup22-psv-mz.121-12c.E4.bin " remove everything including

the boot command I want to have or just the "boot system flash sup-bootflash:c6sup22-psv-mz.121-12c.E4.bin " ?

disk0:c6k

222-psv-mz.122-17d.SXB.bin,1

Re: boot system

Hi Friend,

I am not sure if I understood your point here but I think your query is that "no boot system disk0:" will also remove the boot statement which you want to have it right?

I believe you can just clear all boot statements with "no boot system" command and finally when there is no boot statement left you can configure the boot statement specifically which you want.

HTH, if yes please rate all post.

Ankur

Purple

Re: boot system

Do a sh runn and near the top of the config you will see the boot statements , in config mode add "no " in front of each of the statements . You will need at least one valid statement in there for the box to boot the next time . Also if the images are in disk 0: or bootflash and you don't need them anymore delete and then squeeze them to get rid of them .

388
Views
0
Helpful
4
Replies
CreatePlease to create content