Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Boot Variable editing on 6500 Native

Hello,

I have a 6500 running in native mode. When in rommon I noticed that the boot variables file is extremely congested, full of failed attempts at commands, etc. I'd like to clean up the file in order to reduce confusion if anybody else needs it. Where does the file exist for this (I have two supervisor 2 modules running).

Thanks,

John

1 REPLY

Re: Boot Variable editing on 6500 Native

Hi

are you talking about the boot sequence of the IOS code ?

if thats the case you can alter the boot system command in ur config.

always remove the boot command pointing unavailable files in ur flash disk and keep only one boot command pointing the latest ios code.

if you want to correct something else then do post out the o/p of the same and throw some lite on that requirement..

regds

96
Views
0
Helpful
1
Replies