Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Bootflash problem.

I am using Catalyst 4840G switch.

I tried installing IOS in the switch from the hyperterminal using Xmodem but it is giving an error.

The error displayed "Remote system Not response"

If I use Xmodem from Rommode it is still unable to copy the IOS.Is it the problem with the Flash card.

Can someone help me out with this issue.

1 REPLY
Silver

Re: Bootflash problem.

Please enable "xmodem" protocol transfer from hyperterminal AFTER issuing the xmodem command. Change to higher baud rate. Some cases, it could be a hardware problem also. Hope the following link helps...

http://www.cisco.com/warp/public/130/xmodem_generic.html

105
Views
0
Helpful
1
Replies
CreatePlease to create content