Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

bootflash

Hi

i have already install the native IOS On the PCMCIA.NOW I Want to copy a small IOS From the tftp to the bootflash via a copy command.when i finish the copying now do i need to issue the following commands:

boot system flash bootflash:<file name>

boot sup-bootflash:<file name>

do i need this command "boot sup-bootflash:<file name>"

or this enought "boot system flash bootflash:<file name>:

10xs

4 REPLIES
Blue

Re: bootflash

you only need the first command:

boot system flash bootflash:

or you can use a different source such as:

boot system flash slot0:

Re: bootflash

Hi

Which router r u using?

If there is only PCMCIA card on it,line 1601R, then u do not need to issue any command.

Regards

JD

New Member

Re: bootflash

Hi Friend!

10xs for ur reply;I Have an old 6509-Sup1.

10xs

New Member

Re: bootflash

Hi Friends!

i need only to this?

boot system flash BOOTFLASH:c6sup11−jsv−mz.121−19.E1a

what about these?no need to it or being already exist in the boot flash?

boot bootldr bootflash:c6msfc−boot−mz.121−19.E1a

boot sup− bootflash:c6sup11−jsv−mz.121−19.E1a

10xs

122
Views
0
Helpful
4
Replies
CreatePlease to create content