Bootp to assign ip addresses to switches 1900 and 2924
As I was told on my previous post. I configured dhcp/bootp to assign some reserved IPs to switches that have no configuration yet, then I could telnet, and get the model # and serial # which we need for inventory. but the bootp is not assigning those ips. Also the bootp server is asking me for Unique Identifier, How do I get that for all the switches. I usually assign the ip manually to vlan interface. does the bootp server assign the ip to vlan interface as well, or which interface??
Re: Bootp to assign ip addresses to switches 1900 and 2924
If you can already assigned ip addresses to your switches, you don't need to use bootp to assign them ip addresses, rather you can use an SNMP application and poll the serial #s. Bootp will only function if the switch config is reset (clear config all) or it is the first time configuration. You can find more information at http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2900/c2900/cugcnfg1.htm or http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2900/cgcr29k/initconf.htm
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...