cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
357
Views
5
Helpful
4
Replies

BOOTSYS

alsayed
Level 1
Level 1

HI

I NEED TO UPDATE THE IOS IMAGE TO THE NEW ONE"c3560-ipservicesk9-mz.122-25.SEB4.bin" FROM THE TFTP SERVER VIA THE BOOTSYS COMMAND NOT LIKE COPY TFTP FLASH.WHAT IS THE FULL COMMAND?

10XS FOR UR REPLY

4 Replies 4

ankurbhasin
Level 9
Level 9

Hi Ali,

AFAIK this command is only used to set the boot path for the image in the flash or network.

You can use boot system command to boot your switch directly from tftp server but that will not copy the image into flash of the switch but it will directly load the image into DRAM.

Have a look at this link

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/ffun_r/ffrprt2/frf010.htm#wp1017705

HTH, if yes please rate the post.

Ankur

10xs Ankur for ur time ur help ur effort to serve me!

did u mean the best way it's via the command copy tftp flash

10xs

Ali

Hi Ali,

Somwhow I believe it is best to have the image copied to the on board flash and then set the boot path to boot image from flash.

Use copy tftp flash command to copy the image to flash and later set the boot oath for the new image.

HTH, if yes please rate the post.

Ankur

HI ANKUR

10XS FOR UR REPLY

ALI

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: