BPX 8600 Configuration back-up

[-kostas-]

Greetings all,

We are tryin to get a back-up configuration for our ATM switches (BPX 8600).

We have Cisco Wan Manager (ver 10.4.10 Patch 4) on Solaris.

Through the tool "Config Save and Restore" we are unable to do this.

Reading the "Wan Manager User's Guide" in the appropriate section, it says that this is also possible from the CLI.

However, when I issue the command "dspcnf", the BPX don't have a Backup ID, which is a necessary value for the command "savecnf".

"Savecnf " is the command from the CLI in order to get you back-up configuration. I tried to generate this Backup ID (reading manuals, command references) but with no luck.

Anyone have an idea ?

Thanks in advance,

/kostas

[caparici]

Hi,

Try the following command:

savecnf backup node * 192.168.x.x

where is the name for the backup,

is the node name where you are, and the one you want a backup,

and the last IP, the CWM station's IP.

The asterisk (*) after the node name is important.

Regards,

Cesar