Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BRI dial between Ascend Max and 800/1600 series

Hi,

Anyone know of dial probs between these two platforms? Don't know the Ascend platform but I can find out easily enough if necessary.

Dialing from the Ascend to the the 801/1600 with WIC1-B-S/T is fine but from the Cisco kit to the Ascend is not playing. On PPP and Q931/Q921 debug it appears that the far end is sending a call TERM REQ to which the Cisco router is rightly responding with an ACK. Tried both PAP and CHAP with the same result!!

Following is the debug:

Feb 22 09:18:45.223 GMT: BR0:1 LCP: I TERMREQ [Open] id 3 len 4

Feb 22 09:18:45.231 GMT: BR0:1 LCP: O TERMACK [Open] id 3 len 4

Feb 22 09:18:45.239 GMT: BR0:1 PPP: Phase is TERMINATING [0 sess, 1 load]

Feb 22 09:18:46.235: %LINEPROTO-5-UPDOWN: Line protocol on Interface BRI0:1, cha

nged state to down

Feb 22 09:18:46.319 GMT: BR0:1 IPCP: TIMEout: State Closed

Feb 22 09:18:47.247 GMT: BR0:1 LCP: TIMEout: State TERMsent

Feb 22 09:18:47.247 GMT: BR0:1 LCP: State is Closed

Feb 22 09:18:47.247 GMT: BR0:1 PPP: Phase is DOWN [0 sess, 0 load]

Feb 22 09:18:47.255 GMT: BR0:1 PPP: Phase is ESTABLISHING, Passive Open [0 sess,

0 load]

Feb 22 09:18:47.255 GMT: BR0:1 LCP: State is Listen

Feb 22 09:18:47.291: %ISDN-6-CONNECT: Interface BRI0:1 is now connected to 01132

131152 00c0.7b7b.9a44

Feb 22 09:18:47.295: %ISDN-6-DISCONNECT: Interface BRI0:1 disconnected from 011

32131152 00c0.7b7b.9a44, call lasted 3 seconds

Feb 22 09:18:47.323 GMT: ISDN BR0: TX -> INFOc sapi=0 tei=116 ns=30 nr=31 i=0x08

015A4508028090

Feb 22 09:18:47.331 GMT: DISCONNECT pd = 8 callref = 0x5A

Feb 22 09:18:47.335 GMT: Cause i = 0x8090 - Normal call clearing

If anyone knows of anything I'd appreciate it, before I raise a TAC case. Note that it says normal call clearing at 09:18:47.335 GMT!!

Many Thanks

Ali

2 REPLIES
New Member

Re: BRI dial between Ascend Max and 800/1600 series

Forgot to mention that authentication passes OK

Cheers

Ali

New Member

Re: BRI dial between Ascend Max and 800/1600 series

Got it -

FYI, the Ascend Max doesn't support bidirectional CHAP

103
Views
0
Helpful
2
Replies