I try to bridge an ethernet interface and a serial interface in a router, but I can not communicate the machines of two ports. I use debug packet and there is encapsulation error. I know that that's because ethernet use ethernet encapsulation but serial use hdlc or ppp, so it fail. but is there any solution so that I can communicate with this two ports without routing?
Bridging only works between devices on LANs. You can go LAN--serial--LAN by doing remote bridging. But to get from a box on the LAN to a box on the serial, you need to look at DLSw or protocol translation (depending upon the protocols involved). If you actually were doing LAN--serial--LAN, then its a different problem, but you only mentioned one router with two interfaces.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.