Bridged1483+7200 +multiple static ip's for end cpe
Looking to assign multiple IP's to the LAN side of a dsl cpe on the end of an atm pvc aal5snap via a 7200 router running irb or rbe. Is it possible to assign several consecutive ip's from the bridge group to one device other than sereral host routes for the ip's on the 7200? Trying to conserve ip's.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...