I'm proposing a project to migrate from a hub/spoke bridged WAN (don't even ask) to a full routed WAN and need to know if I can do bridging and routing at the same time just for the purposes of migration and then get rid of bridging. Thanks!
The people who set it up a few years ago did not understand the grave consequences of bridging 7 spoke sites and did not know how to program routing so now I have to get rid of the bridging and enable routing. Can you explain what IRB is or point me in the right direction?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...