Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Bridging Between VLANs with a Cat 4000 Supervisor IV

From documentation on the Cisco Web site it is aparrent that bridge groups are not supported on the 12.1(12c)EW1 running on a Supervisor IV.

How do you therefore bridge between VLANS on a Cat4000 with a Supervisor IV.

Any assistance would be appreciated.

2 REPLIES
New Member

Re: Bridging Between VLANs with a Cat 4000 Supervisor IV

Configure a 'router-on-a-stick' concept. That would be configuring separate interfaces or more likely sub-interfaces for each vlan and set encapsulation for trunking (dot1Q most likely).

Cisco Employee

Re: Bridging Between VLANs with a Cat 4000 Supervisor IV

You cannot configure bridging on this platform

79
Views
0
Helpful
2
Replies
CreatePlease to create content