We have the following scenario: two 2621 routers at the end of a point-to-point serial line. The routers have the integrated CSU/DSU module connecting to the WAN, and the fast ethernet port on the LAN. The FE ports both have IP addresses in the segment, 10.11.1.1 and 10.11.1.2. Both routers are set up for bridging, with nothing else configured (no access lists etc)
We wish to remote manage these devices and have found the following situation. When we telnet to the box from the local segment (a pc attached to the switch to where the router is plugged in) the router responds to the telnet request. When we try telnet across the serials to the same Ip address, it doesn't respond.
This is the same on both ends. Data traffic is passing fine through the devices but we cannot telnet remotely to the boxes.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.