Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Bridging POS

Has anyone ever bridged a gig interface or vlan over POS?

I have a requirement to bridge non-IP traffic from an interface or vlan on a 6513 across a POS OC12 PA on a Flex-wan card to another 6513 with the same config. I don't see the bridging command under the POS interface so I was wondering if this is possible.

Thanks,

Tim

1 REPLY
New Member

Re: Bridging POS

89
Views
0
Helpful
1
Replies
CreatePlease to create content