Switch#9 [4006 NmpSW 7.4(3)] is to share a section of its gigabit Ethernet module 6 [ws-x4448-gb-rj45 hw:1.0] which has been placed in VLAN 10,
 and switch#1 [4006 NmpSW 6.3(3)] requiring access to the "bridged" VLAN 10 on switch#9, via port 1 on one of its modules, 3, a ws-x4424-gb-rj45.
Switch#9 is in network 10.159.0.0 and switch#1 in network 184.108.40.206.
On switch#9 VLAN 10 has been set up for ports 33-48, port 48 will be the bridge port, currently set to 1000Mbps, with a cross-over cable installed and connected to switch#1 we get a status "inactive" for port 48.
On switch#1 port 1 we get a status not connect.
Weve tried different cross-over cables, undertaking a module reset on switch#9s module 6, disabling and re-enabling the bridge ports at each switch to avail, as well as disabling and enabling CDP.
My test systems, a 4003 & 2950, with a section of one of the 4003 modules VLANd  and bridged works fine.
I think the main problem is your cross-over cable.It is different between normal 100baseTX cross-over.It's like 1-3,2-6,3-1,4-7,5-8,6-2,7-4,8-5.Because both modules are 1000baseT module.Any other problem can send email to firstname.lastname@example.org
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...