Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Broadcast on Point to point serial Link

Any idear where this may be coming from.

There is no dynamic routing enable on the link.

1 REPLY

Re: Broadcast on Point to point serial Link

Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, it’s often difficult to do so for this type of issue.

To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

118
Views
0
Helpful
1
Replies
CreatePlease to create content