Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Browsing W2K Network Neighborhood

Hi,

I am trying to enable DialUp Clients (to a 3620) browse the Corporate Microsoft Network.

I have configured

1. ip helper-address in the "interface dialer" config.

2. Enabled 137,139 in "ip forward-protocol".

The address pool is configured on the Router and is on a different subnet than the W2K domain controller.

Dialup connection on Windows XP is configured for "Client for Microsoft Network".

Afetr getting connected i get WINS, DNS addresses and can "ping" the domain controller. However i cannnot still see\browse the "network places" ?

Any hints ?

Regards \\ Naman

1 REPLY
Bronze

Re: Browsing W2K Network Neighborhood

I believe you also need to enable port 138.

74
Views
0
Helpful
1
Replies