This is a bank network with a hub and two remote sites. All three sites have an ATM teller machine connected directly to the router serial port. There's a dedicated circuit connection between these sites. There's also a 3rd party vendor network that provides server storage location for these ATM traffic that is connected to the hub site via a 56K DDS FR circuit. All these sites currently have Motorola routers including the vendor. I am replacing the hub site motorola with a cisco 3620 with serial WAN modules. I need to configure the cisco so I can forward X25 encapsulated ATM traffic from the two remotes and also the hub site to the vendor's servers. And vice verca. I have given up on the idea of doing BSTUN between Motorola and Cisco as I don't think motorola supports it. Coonfig help please.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...