Building EtherChannel between C6509 Switches using WS-X6548-GE-TX Ethernet card module
One more question relating to EtherChannel. We have a 2x1gbps EtherChannel link built between an Access and Core switch in our Data center using two ports in a WS-X6548-GE-TX linecard module. However, I read in one Cisco document that only one port per module should be used in an EtherChannel because of the ASIC configuration in this type of module which limits the channel to 1gbps.
Please can you tell me whether this is still the case with C6509 running IOS 12.x. Otherwise, what is the recommended selection of ports for EtherChannel using the WS-X6548-GE-TX ethernet modules in 6509 switches.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...