Hi All,
I have a 7507 using RSP4+ which boots up OK, however, if I initiate a selftest from boot prompt, it gives me the following errors:
==============================
System Bootstrap, Version 12.0(10r)S1, RELEASE SOFTWARE (fc1)
Copyright (c) 2000 by cisco Systems, Inc.
SLOT 2 RSP is system master
RSP4 platform with 262144 Kbytes of main memory
AUTOBOOTVAR (BOOT) env variable isn't set. Please set it to point to a
non null string. Attempting to load the first image in disk0 or slot0.
monitor: command "boot" aborted due to user interrupt
rommon 1 >
rommon 1 > selftest
The extended selftest is configured as "disabled"
do you wish to change the selftest configuration? y/n [n]: y
enable "extended selftest"? y/n [n]: y
You must reset or power cycle to run selftest
rommon 2 > reset
System Bootstrap, Version 12.0(10r)S1, RELEASE SOFTWARE (fc1)
Copyright (c) 2000 by cisco Systems, Inc.
*** Bus Error (Load) Exception ***
Access address = 0xbfc40000
PC = 0xbfc17fa4, Cause = 0x1c, Status Reg = 0x30408403
DCL Masked Interrupt Register = 0x000000bf
DCL Interrupt Value Register = 0x0000001c
MEMD Int 6 Status Register = 0x00000000
ROM Monitor Can Not Recover From Exception
A Board Reset Is Issuedþ
System Bootstrap, Version 12.0(10r)S1, RELEASE SOFTWARE (fc1)
Copyright (c) 2000 by cisco Systems, Inc.
SLOT 2 RSP is system master
RSP4 platform with 262144 Kbytes of main memory
==============================
Is this anything to worry about?
Any feedback would be appreciated.
Thanks in advance,
Chee.