05-19-2003 09:24 PM - edited 03-02-2019 07:27 AM
Dear Friends,
Can any one let me Know how to Caliculate the BW based on the reading from sh inter ser output from 5 minute i/p and o/p readings. will this reflect the Through put or any other parameter.
Rgds
Kalyan
05-20-2003 02:41 AM
Give the correct bandwidth under the interface.
Then observe the tx load, rx load, these values give how much bandwidth is utilized on the interface unless u provided correct bandwidht under the interface.
Because, router uses whatever the value given in this command to calculate the load. by default 1544kbit. To reflect the correct values, change it to the bandwidth of the interface
-Deepu
05-20-2003 03:06 AM
Hi deepu,
I defined 256k on my serial interface. Our actual BW is also the same. If I get 5 min I/p rate as 7000 bits/sec and 5 min o/p rate as 5000bits/sec,then what is the effective b/w utilisation..?
Also when I am using throughput monitooring tool (like whats up gold)
I get different through puts when i change the packet size.. can u pl. clarify me on this.
Rgds
srini
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide