Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

BW Measurement

Dear Friends,

Can any one let me Know how to Caliculate the BW based on the reading from sh inter ser output from 5 minute i/p and o/p readings. will this reflect the Through put or any other parameter.

Rgds

Kalyan

2 REPLIES
New Member

Re: BW Measurement

Give the correct bandwidth under the interface.

Then observe the tx load, rx load, these values give how much bandwidth is utilized on the interface unless u provided correct bandwidht under the interface.

Because, router uses whatever the value given in this command to calculate the load. by default 1544kbit. To reflect the correct values, change it to the bandwidth of the interface

-Deepu

New Member

Re: BW Measurement

Hi deepu,

I defined 256k on my serial interface. Our actual BW is also the same. If I get 5 min I/p rate as 7000 bits/sec and 5 min o/p rate as 5000bits/sec,then what is the effective b/w utilisation..?

Also when I am using throughput monitooring tool (like whats up gold)

I get different through puts when i change the packet size.. can u pl. clarify me on this.

Rgds

srini

259
Views
0
Helpful
2
Replies