Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

BW upgradation

dear all,

when I do bw upgradation on GigabitEthernet9/1/0.13 on GSr it gives message like

Adjusting exceed burst to match hardware limit of 16777215 bytes

what it is exactly

pl. guide

mahesh

1 REPLY
Silver

Re: BW upgradation

Reason is a very large burst value . Try either letting the system pick the values for you, or use somewhere in the neighborhood of tens or hundreds of *milliseconds* for the burst sizes.

otherwise use the rate-limit policing command in your interface for limiting the size.

104
Views
0
Helpful
1
Replies