Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

C2650 reload when swich on - %SYS-2-MALLOCFAIL error

I have a Cisco 2650 router with 64MB/16MB memory. The IOS version is 12.2(8)T5. I use a NM-HDV-1E1-30E module.

When I Switch ON the router (or reload it manually), it returns every time a Malloc error and reboots by itself.

After the reload, everything is fine, Interfaces and Controllers are up, DSP initialised.

What it could be? Not enough memory? Hardware / Software problem?

Thanks for your help.

The errors messages returned are:

%LINK-3-UPDOWN: Interface ISDN-VOICE 1/0:15(30), changed state to up

%LINK-3-UPDOWN: Interface ISDN-VOICE 1/0:15(31), changed state to up

%MGCP-3-INTERNAL_ERROR: Not able to create the profiletdm_eadi_post_configs: TDM Backplane not enabled

%SYS-2-MALLOCFAIL: Memory allocation of 24 bytes failed from 0x803C9578, alignment 0 Pool: Processor Free: 0 Cause: Not enough free memory

Alternate Pool: None Free: 0 Cause: No Alternate pool

-Process= "ISDN", ipl= 0, pid= 102

-Traceback= 803C6E6C 803C8B7C 803C957C 800E60C0 800CE3A4 800CD2C8 800CE044 800E5A60 800BC230 800BC200

%SYS-2-NOBLOCK: printf with blocking disabled.

-Process= "Pool Manager", ipl= 0, pid= 5

-Traceback= 80325F44 803C6ED4 803C8B7C 80377824 803D42E8 803E91C4

=== Flushing messages () ===

Nested exception_rom_monitor call (2 times)

Unexpected exception to CPUvector 1000, PC = 815A4424

-Traceback= 815A4424 803E46A8 803E575C

*** System received an unknown failure ***

signal= 0x7, code= 0x1000, context= 0x8230fcc8

PC = 0x815a4424, Vector = 0x1000, SP = 0x82310f14

System Bootstrap, Version 12.2(6r), RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac

Copyright (c) 2001 by cisco Systems, Inc.

C2600 platform with 65536 Kbytes of main memory

1 REPLY
Bronze

Re: C2650 reload when swich on - %SYS-2-MALLOCFAIL error

I think the issue is insufficient DRAM; I'm not sure what image you have loaded, but here are the recommendations for 12.2T and the 2600:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122relnt/xprn122t/122tfeat.htm#xtocid56

We also have a memory calculator:

http://www.cisco.com/cgi-bin/Support/MemCalc/mem-calc.pl

280
Views
0
Helpful
1
Replies