Our Plant runs 3 ethernet LAN's, 2 for plant processing control(DCS) and 1 business applcations LAN. We have a requirement to connect certain hosts (+- 5) on the Bus. LAN to either of the DCS lans. Each LAN has it's own IP address :
DCS1 = 22.214.171.124/24 (10 hosts via hubs)
DCS2 = 126.96.36.199/24 (10 hosts via hubs)
Bus. = 10.2.0.0/16 (130 hosts via hubs).
Due to network traffic, the LANS must be segregated from each other. We have a C3550-24-SMI switch and we initially thought we could use VLANS with routing between them to do this but we think we may need another router to do this. If anyone has suggestions on the best way to configure the switch (we have limited experience here) it would be greatly appreciated. We have an Internet connection that is defined as the default gateway for all the bus. lan hosts.
I have done some testing based on your info B.go and it seems to be working great, so thanks again. How do I control traffic between the Lans, is this through ACL's for each port limiting them to specific IP host adresses or is there some other mechanism available ?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.