cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
242
Views
0
Helpful
3
Replies

C6K Gigabit Ethernet Card w/o SFM2

chewshk
Level 1
Level 1

Hi,

Can a Catalyst 6500 with Sup2 (MSFC2 & PFC2) using this Gigabit Ethernet Card (WS-X6816-GBIC) work without installing the SFM2 (WS-X6500-SFM2) ?

Can it work, however, cannot perform Distributed Switching only ? Pls advise ....

Rgds

3 Replies 3

ola
Level 1
Level 1

HI,

See the datasheet for gigabit module on catalyst 6K :

http://www.cisco.com/warp/public/cc/pd/si/casi/ca6000/prodlit/c60ge_ds.htm

The module only support Switch fabric switching mode.

You can verify it with the software advisor, I suppose.

regards

chewshk
Level 1
Level 1

Hi,

The Datasheet mentioned about its capabilities to deliver switched fabric feature. However, if I don't install an SFM2, will the WS-X6816-GBIC work (even without the extra features) ?

p/s : I tried the configurator. Apparently, I cannot configure the WS-X6816-GBIC without adding the SFM2 in.

Rgds

You must install a Switch Fabric Module along with the WS-X6816-GBIC in the Catalyst 6500 Series switch.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/6000hw/mod_inst/01overvw.htm#xtocid30

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: