Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

C8540MSR Log and Show Tech analysis

IS it possible to pin point further using these SHOW TECH and LOGs other than say this could be SP, RP or ARM fault in the C8540MSR switch.

1 REPLY
New Member

Re: C8540MSR Log and Show Tech analysis

I was trying to understand the slot 5,6,7 redundancy mechanism in C8540MSR switch.

I know that two SPs are needed and one is redundant. How can one give from the SHOW TECH the answers to the following questions:

1. Which Interface Cards are using the SP in slot 5.

2. Which Interface cards are using the SP in slot 7?

3. How can we tell that SP in slot 6 was in redundant mode and that if SP in slot 5 was pulled out then SP in slot 6 will become active for the Interface Cards that were originally using SP in slot 5 before.

Basically I wish to fully understand the relation between SP 5, 6, 7 and the Interface Card Slots 0,1,2, 3 and Interface Card slots 9,10,11,12.

441
Views
0
Helpful
1
Replies
CreatePlease to create content