I am new to the Cisco 877 router. When I connect a computer to one of the four FE ports I am unable to access the router. I am given an IP address by the DHCP scope but I am unable to telnet, HTTP or HTTPS into the router.
I reset the router back to the factory setting and was going to try the SDM. Same problem. Even with a factory reset, I get a DHCP address (10.10.10.2) but I am unable to ping, HTTP or telnet into the router. The SDM is also unable to connect to the router.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...