We want to connect our new 2600XM to our ISP through a full T1 (encapsulation frame-relay) and want to make sure what module we need for that. I think we can use a WIC-1DSU-T1 module but am not positive. Also, the wall jack from the ISP is labeled RJ48X. What I've read about cabling it looks like I can use a RJ48C straght-through cable. Can anyone verify that? Any help for a newbie would be much appreciated
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...