Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cabling considerations: 6260 to 827

Should the Tip pin from the champ (RJ-21 6260 side) connector be connected to the tip pin (pin 3) on the RJ-11 (827 side) or to the ring pin ?

Thanx

Fred

debulois@fr.ibm.com

1 REPLY

Re: Cabling considerations: 6260 to 827

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

88
Views
0
Helpful
1
Replies
CreatePlease to create content