I am going to be configuring a UBR10000 supporting DOCSIS 3.0 modems. I will be using channel bonding. At the Headend there will be a Call Manager installed. IP Phones (SCCP) will be co-located with the Cable Modems. The network looks like this:
So my question is, what are the Best Practice recomendations for QoS to support the VoIP and Call Setup traffic going across the RF plant? Specifically I'm looking for CMTS configuration suggestions and Cable Modem config file suggestions.
Re: Call Manager over DOCSIS - Best Practice QoS ???
Thanks for the response, and I agree giving DSCP EF priority is best. But the question is how to give it priority. There are a lot of tools available in the CMTS for doing that. Which QoS tools and configurations are the best practices is what I am looking for.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...