CallManager 6.1 to 8.6 upgrade. Brooktrout SR140 Issue?
We currently have an issue with our Brooktrout SR140 FoIP software. After upgrading from Cisco Call Manager 6.1 (2) to Cisco Call Manager 8.6.2(a) 22.214.171.12400-2 we have been unable to send faxes. Our communications section has advised that the settings on Call Manager are correct.
Are there any known inoperabilty issues with CallManager 8.6.2 and SR140? I appreciate this is a minimal amount of information.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...