Campus Area network

[machaleshamsundar]

hello exports,

i ve a 1 6513 as a core switch and 4510 as a redundant swich connected by using 10GE. other switches are 3750 and 500G .i want to configure Vlan and active redundancy. can i create same SVI on both the 6513 and 4510 switch. i want 6513 and 4510 as only L3 in my n/w.i m using basic image. shoule i use HSRP?????

if someone solves this issue i will be very thankful.

sham

[AJAZ NAWAZ]

Dear Sham,

If you are using a BasicIP image and it supports HSRP then the solution you are proposing will work and as such provide you with redundancy.

hth,

Ajaz Nawaz

[devang_etcom]

as you are going to have multiple vlan then you can have redundancy with loadsharing also using HSRP... it means you can have multiple standby group and can deploy the loadsharing...

regards

Devang

[machaleshamsundar]

hi devang ,

is there another solution than HSRP to get redundancy in my network. will i get active redundancy.

sham

[devang_etcom]

you can use GLBP but for that you have to check for IOS... your IOS should be support the GLBP ...

regards

Devang