Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Campus Area network

hello exports,

i ve a 1 6513 as a core switch and 4510 as a redundant swich connected by using 10GE. other switches are 3750 and 500G .i want to configure Vlan and active redundancy. can i create same SVI on both the 6513 and 4510 switch. i want 6513 and 4510 as only L3 in my n/w.i m using basic image. shoule i use HSRP?????

if someone solves this issue i will be very thankful.

sham

4 REPLIES
Silver

Re: Campus Area network

Dear Sham,

If you are using a BasicIP image and it supports HSRP then the solution you are proposing will work and as such provide you with redundancy.

hth,

Ajaz Nawaz

Re: Campus Area network

as you are going to have multiple vlan then you can have redundancy with loadsharing also using HSRP... it means you can have multiple standby group and can deploy the loadsharing...

regards

Devang

New Member

Re: Campus Area network

hi devang ,

is there another solution than HSRP to get redundancy in my network. will i get active redundancy.

sham

Re: Campus Area network

you can use GLBP but for that you have to check for IOS... your IOS should be support the GLBP ...

regards

Devang

123
Views
0
Helpful
4
Replies
CreatePlease login to create content