ANI can't discover the network but you can enter the devices manually. It'd be laborious, but you could walk through the arp caches on the devices moving outward and add the Cisco devices you find manually to the CM maps.
Could you explain the step-by-step procedure for manually adding devices to the CM map. I understand that CM does not support PIX firewalls and VPN concentrators (obviously they do not support CDP). I need to add these to the map though to complete the network.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...