03-07-2003 09:36 PM - edited 03-02-2019 05:42 AM
RME 3.4 - CM 3.2
We have Remote sites connected via IPVC's Frames coming into a ATM (OC-12) and they do not show connected to the ATM Cloud. ATM is configured for ILMI and CDP is running on Serial interface. What do I have to change for them to show connected? But you cannot run CDP on ATM interfaces, and ILMI will not run on serial. But they are connected.....
03-14-2003 07:23 AM
I guess you are running ATM over serial interfaces? If yes, you have to use ATM DXI Encapsulation.
More infor on ATM DXI is here:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fwan_c/wcfatm.htm#1004591
03-14-2003 08:17 AM
No. It's a frame on the far end, WIC and ATM on the head. Config looks like this: Remote router
interface Serial0/0
mtu 4470
no ip address
ip directed-broadcast
encapsulation frame-relay IETF
no ip mroute-cache
no fair-queue
service-module t1 remote-alarm-enable
cdp enable
frame-relay lmi-type ansi
!
interface Serial0/0.1 point-to-point
description Connected to circuit 99YBGA 176514//ACSO
ip address 99.999.999.99 255.255.255.255
ip directed-broadcast
frame-relay interface-dlci 16 IETF
!
Head end router
interface ATM1/0.71 point-to-point
description PMG Springbrook Clinic IPVC 99YBGA 176514//ACSO
ip address 99.999.999.98 255.255.255.255
no ip mroute-cache
pvc PMGSpringBrk 1/71
ubr 1544
encapsulation aal5snap
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: