Campus Manager>Topology Services - IPVC's not showing connected

[Ben.Chaltraw]

RME 3.4 - CM 3.2

We have Remote sites connected via IPVC's Frames coming into a ATM (OC-12) and they do not show connected to the ATM Cloud. ATM is configured for ILMI and CDP is running on Serial interface. What do I have to change for them to show connected? But you cannot run CDP on ATM interfaces, and ILMI will not run on serial. But they are connected.....

[mchin345]

I guess you are running ATM over serial interfaces? If yes, you have to use ATM DXI Encapsulation.

More infor on ATM DXI is here:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fwan_c/wcfatm.htm#1004591

[Ben.Chaltraw]

No. It's a frame on the far end, WIC and ATM on the head. Config looks like this: Remote router

interface Serial0/0

mtu 4470

no ip address

ip directed-broadcast

encapsulation frame-relay IETF

no ip mroute-cache

no fair-queue

service-module t1 remote-alarm-enable

cdp enable

frame-relay lmi-type ansi

!

interface Serial0/0.1 point-to-point

description Connected to circuit 99YBGA 176514//ACSO

ip address 99.999.999.99 255.255.255.255

ip directed-broadcast

frame-relay interface-dlci 16 IETF

!

Head end router

interface ATM1/0.71 point-to-point

description PMG Springbrook Clinic IPVC 99YBGA 176514//ACSO

ip address 99.999.999.98 255.255.255.255

no ip mroute-cache

pvc PMGSpringBrk 1/71

ubr 1544

encapsulation aal5snap