Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Campus Manager>Topology Services - IPVC's not showing connected

RME 3.4 - CM 3.2

We have Remote sites connected via IPVC's Frames coming into a ATM (OC-12) and they do not show connected to the ATM Cloud. ATM is configured for ILMI and CDP is running on Serial interface. What do I have to change for them to show connected? But you cannot run CDP on ATM interfaces, and ILMI will not run on serial. But they are connected.....


Re: Campus Manager>Topology Services - IPVC's not showing connec

I guess you are running ATM over serial interfaces? If yes, you have to use ATM DXI Encapsulation.

More infor on ATM DXI is here:

New Member

Re: Campus Manager>Topology Services - IPVC's not showing connec

No. It's a frame on the far end, WIC and ATM on the head. Config looks like this: Remote router

interface Serial0/0

mtu 4470

no ip address

ip directed-broadcast

encapsulation frame-relay IETF

no ip mroute-cache

no fair-queue

service-module t1 remote-alarm-enable

cdp enable

frame-relay lmi-type ansi


interface Serial0/0.1 point-to-point

description Connected to circuit 99YBGA 176514//ACSO

ip address 99.999.999.99

ip directed-broadcast

frame-relay interface-dlci 16 IETF


Head end router

interface ATM1/0.71 point-to-point

description PMG Springbrook Clinic IPVC 99YBGA 176514//ACSO

ip address 99.999.999.98

no ip mroute-cache

pvc PMGSpringBrk 1/71

ubr 1544

encapsulation aal5snap

CreatePlease to create content